We hope you have enjoyed the SRGC Forum. You can make a Paypal donation to the SRGC by clicking the above button

Author Topic: Greenhouse - ridge leak  (Read 235 times)

Vinny 123

  • Full Member
  • ***
  • Posts: 202
  • Country: gb
Greenhouse - ridge leak
« on: October 02, 2024, 09:43:54 AM »
My greenhouses are very typical aluminium-framed, with the ridges being complicated aluminium extrusions which includes C-shaped (female) sections which act as the hinges for the roof vents, which have corresponding (male) profiles which slide into the C-shaped part of the ridge bar.

Anyone who has erected an aluminium greenhouse will follow that (hopefully).

The very top of the vents have started leaking, which, with all the recent rain, means quite a wet floor inside the greenhouse.
The inner part of the ridge bar forms a flange to which the roof bars are attached, and the water is dripping from that on one side of each roof vent.

I have had things apart and cleared build-up of moss/lichen and even worked the vents a few inches eaither way along the ridge bar, back to front of the greenhouse, but it still leaks.

How, where is the water making its way in? Why? Cure? (It should not need caulk, it was water-tight for way over ten years without any.)



Graeme

  • Hero Member
  • *****
  • Posts: 716
  • Country: england
Re: Greenhouse - ridge leak
« Reply #1 on: October 06, 2024, 03:15:19 PM »
Best thing to do is actually go in there when it's raining and see exactly where the water is coming from

If you can slide it out - remover the glass - clean the sealing strips either side and then refit with new clips



"Never believe anything you read on the Internet" Oscar Wilde

 


Scottish Rock Garden Club is a Charity registered with Scottish Charity Regulator (OSCR): SC000942
SimplePortal 2.3.5 © 2008-2012, SimplePortal